How to Tell If an Outside User Is on Your Wireless Network

IndiaGazette

Editor

posted on 18 years ago — updated on 1 second ago

28
views

Wireless security is very important these days. You don't want anyone siphoning bandwidth or getting into your network to perform malicious attacks. Since every wireless router is different, this article will discuss the basics and use one of the most popular wireless routers, the Linksys WAP54G as an example. The steps for your router may differ. This guide assumes you are connected to your router (either through a network cable or over its wireless signal) using DHCP correctly.

Steps

Open your web browser and input your default gateway's IP address. To find this: Go to Start > run, and type cmd Type ipconfig and press enter. It will list the default gateway here. Once you have your default gateway address, open your web browser and type it in the URL bar.

Input your router's username and password. Default for Linksys products is usually username: (blank) password: admin Default for Netgear routers is Username: admin password: password Default for Dlink routers is Username: Admin; Password: (blank). Default for Siemens routers is Username: Admin; Password: admin (all lowercase). Default for zyxel-p600-t1a is 1234 Default User Names and Passwords can be found sometimes on the bottom of the router, on the label or using Google. If you are having trouble finding the UN and PW then try http://www.portforward.com this website is usually used for opening ports for P2P programs and games,but when it shows you how to open your ports it tells you the default UN and PW for the router. The router list is extensive.

If you are using the default username and password, go to the Administration tab to change it to something more secure. From the Router's user interface you will probably have a setting to log Users going through the router--enable it if not already.

Get a pen and paper, and use the steps shown above finding the default gateway to find your MAC or also called physical address of all computers/devices that use wifi/wireless in your home or that will be using it and write them down. From time to time check the log to see if any unknown addresses show up. If so, then someone is leeching off your internet. MAC/physical addresses are unique hexadecimal code that identifies each Network card inside every PC that uses Ethernet. No two MAC addresses are the same.

Finding who is on your network

Navigate to the Setup tab.

Scroll down until you see 'DHCP Server' if it is enabled, continue to the next step. If it isn't enabled, enable it.

Click on the "Status" tab and then on "Local Network" just below the main tabs.

Click the button that says "DHCP Clients Table". This list will tell you the computer name of everyone connected to your network on DHCP (DHCP automatically configures a computer's IP and DNS settings. This only works if everyone connected uses DHCP. If someone connects and uses their own static address, then this will not show them.)