Resetting Your Checkmate Alarm System in with a Valet Switch
Identify your valet switch. The valet switch is either a toggle switch or a push button that disarms all alarm functions except the remote panic and remote door lock functions. This eliminates the need to hand your remote to garage mechanics and valets, giving the switch its name. Usually this switch is located somewhere under the dash, perhaps on the left kick panel. A valet switch is a standard piece of equipment with most factory and aftermarket alarm systems. Using the valet switch should serve to reset your alarm. Your alarm should stay shut down as long as you are in valet mode. You should be aware that this disables you alarm system, meaning that your car is unprotected if you use it as a long term solution.
Turn the ignition key to the on position. It is not necessary to start the car. As a matter of fact, you may find that you cannot start the car if you try.
Toggle the switch or push the button. This will activate the valet bypass. The alarm should now be disabled.
Resetting Your Checkmate Alarm System With the Car Battery
Locate the battery. Usually the battery is located under the hood or in the trunk. Occasionally it can be found other places, such as under a rear seat.
Disconnect the battery ground cable. This will cut power to the entire car. The ground is the cable connected to the negative battery terminal and is usually black.
Lock all doors manually. Lock all passenger doors from inside the vehicle and the driver's door from outside with the key (you won’t be able to use the remote).
Open the hood. This is only necessary if the battery is under your hood.
Find the hood position detection switch. You must hold this down when you connect the battery. Note that your alarm may not be equipped with a hood position detector. The detector looks like a plunger switch pointing upward. It will be pressed down when hood is closed, telling your alarm that nobody has tampered with the hood. The plunger will usually be enclosed within a rubber boot. If your battery is not under your hood, it is not necessary to have the hood open and manually depress the hood position detector. You can simply close the hood.
Reconnect the battery ground cable. This will restore power to the vehicle with all doors locked, trunk locked, and the hood position switch held down. Having everything closed and locked up will signal to your alarm that no intrusions have taken place, and this should reset your alarm. If all is well the horn will be silent, and the headlights will stop flashing. The car is ready to start.
Resetting Using the “Wait It Out” Method
Sit in your driver’s seat. Be patient and the alarm will reset itself.
Wait for the alarm to reset. Once the alarm resets it will still be armed, but will not be activated.
Turn the key to the “on” position. This will disarm your alarm, effectively resetting it.
Comments
0 comment